Reekie Experience
1786 25/01/2006 ROCKER BLOCK
1786 25/01/2006 TOP BEARING BLOCK
1786 25/01/2006 KEY PLATE
1778 23/01/2006 BRUSH PLOUGH CARRIERS c/w MK1,2,3,12
1779 23/01/2006 TOP LOCATION
1779 23/01/2006 MAIN LOCATION
1779 23/01/2006 TOP PLATE
1779 23/01/2006 PIVOT LOCATION
1773 19/01/2006 DUPLEX PLUG DRILLING
1770 18/01/2006 SPINDLE ARM WASHER (REF 4)
1770 18/01/2006 CASTLE NUT REF 3
1770 18/01/2006 SPIDER GUIDE SPINDLE ARM
1770 18/01/2006 1/4″ DIA X 4″ LG SPLIT PIN REF 12
1770 18/01/2006 WEAR PLATE CARRIER REF 1
1766 17/01/2006 IMPELLER REGULATING ROD
1769 17/01/2006 Car Shredder anvil seating, insitu mill 220 wide x 2600 long horizontal face and 250 wide x2,600 long vertical face to clean up
1760 13/01/2006 DAVIT WASHER
1760 13/01/2006 DAVIT MASTS 65250 SERIES
1760 13/01/2006 DAVIT CAPSTAN NUT
1760 13/01/2006 65250-CODE A DIAPHRAGM PLATE 35 MM THICK
1760 13/01/2006 PHOSPHER BRONZE WASHER DAVIT WASHER
1757 12/01/2006 COOKER SHAFT REPAIR – WELDING AND TURNING
1756 10/01/2006 RFA ROSALIE – DG PAD MACHINING
1752 05/01/2006 RH ACCESS DOOR
1752 05/01/2006 LH ACCESS DOOR
1752 05/01/2006 ACCESS DOOR FRAMES
1750 23/12/2005 M64 X 4MM FINE PITCH HIGH TENSILE 12.9 GRADE SELF COLOURED NUT
1750 23/12/2005 FRAGMATISER BEARING BLOCK STUD : M64 X 1000MM LG – SCREWED 130MM EACH END
1747 22/12/2005 2B Y JET SPRAYER ASSY
1748 22/12/2005 hire of two sets of heavy duty 3 axis insitu milling equipment with pp, similar to SO1438, for milling 1500×1000 pads
Case Studies
View All >
Tartan Platform – Releasing Caisson from Dead Weight Support
The customer required a robust solution to release one of their caissons from a unique dead weight support structure. The caisson had a cone feature that nested into a mating cone in the platform support.
Find Out More >
Machining of Hang off Module (HOM) Rails on Deep Blue Vessel
The rails that the HOC runs on had become extremely worn and were affecting operations. The pair of rails, 11,080 mm long x 230mm wide, needed to be machined flat and to a common plane within 0.25mm.
Find Out More >