Reekie Experience
570 18/11/2003 10″NB SCH40S HEADER – DRILLING 3-OFF HOLES AT 100MM DIA
569 14/11/2003 DESICCANT BASE
566 10/11/2003 Mk 8 SSE at Chapel Street Works, bore 5.325″ dia x 76.2 length, bore 9.5″ dia x 76.2mm length, mill flats by 76.2 depth
561 07/11/2003 INSITU BOILER FEED PUMP COVER MACHINING – NOV ’03 OUTAGE
562 07/11/2003 PLATE & CYLINDER ASSEMBLY
562 07/11/2003 2″-11.1/2 NPTF ADAPTOR
562 07/11/2003 1.1/2″-11.1/2 NPTF ADAPTOR
562 07/11/2003 1.1/4″-11.1/2 NPTF ADAPTOR
562 07/11/2003 1″-11.1/2″ NPTF ADAPTOR
562 07/11/2003 3/4″- 14NPTF ADAPTOR
562 07/11/2003 1/2″-14 NPTF ADAPTOR
562 07/11/2003 ADAPTOR RECEIVER (4 off holes not to be drilled)
557 05/11/2003 Stiffener Moulding for 8″ ( 301 nominal )
558 05/11/2003 CRANE SEAT MACHINING
556 04/11/2003 STIRRUP PADS (MK3)
556 04/11/2003 STIRRUP CAPS (MK2)
556 04/11/2003 STIRRUP (MK1)
C/W LOCKING PLATES (MK9) & NUTS (MK10 )
554 03/11/2003 1000 ONE PIECE UPPER FRAME MEDIUM COARSE TO ROUGH 1459.75 DIA FINSH : TURN 1182 MM DIA : CHECK TAPER AND WELD IF CUSTOMER REQUIRES
555 03/11/2003 GLAND SEAL COOLER MACHINING : 4-OFF FACES AND DIVIDING CHANNELS
552 31/10/2003 MV Dea Mariner – ship’s rudder tube – bore insitu
549 30/10/2003 ASSEMBLY OF 3B Y-JET ATOMISERS
551 30/10/2003 COUPLING YOKE HANDLE
551 30/10/2003 LOCKING RINGS
551 30/10/2003 HINGE PIN 3/8″ X 1.1/8″LG
551 30/10/2003 ATOMISER TAILPIECE 2B ‘Y’ JET ATOMISER
551 30/10/2003 ATOMISER BODY
551 30/10/2003 WASHER (Ref 36)
551 30/10/2003 NUT
551 30/10/2003 2B CAP NUTS
551 30/10/2003 TORQUE RING
Case Studies
View All >
Tartan Platform – Releasing Caisson from Dead Weight Support
The customer required a robust solution to release one of their caissons from a unique dead weight support structure. The caisson had a cone feature that nested into a mating cone in the platform support.
Find Out More >
Machining of Hang off Module (HOM) Rails on Deep Blue Vessel
The rails that the HOC runs on had become extremely worn and were affecting operations. The pair of rails, 11,080 mm long x 230mm wide, needed to be machined flat and to a common plane within 0.25mm.
Find Out More >