Reekie Experience
6948 04/02/2015 POSITIONING RING ( 4 HALVES )
6943 29/01/2015 Mast U Vessel, On site machining of four Mounting Pin Brackets welded to vessel
6940 28/01/2015 MOUNTING PINS
6940 28/01/2015 MOUNTING PINS
6940 28/01/2015 DETAIL OF MACHINING FOR ANTI-CLOCKWISE FLAME HOLDER BARREL
6940 28/01/2015 DETAIL OF MACHINING FOR CLOCKWISE FLAME HOLDER BARREL
6941 28/01/2015 Vessel Door Machining. Machine to doorway to increase size to required dimensions
6932 26/01/2015 Dundreggan fish pass
6934 26/01/2015 FI Sheave Wheel
6935 26/01/2015 RING SUPPORT
6930 23/01/2015 Herbold Cutter, line bore 2 sets of hinges, apporx Ø80, machine our 4 off dowel holes approx Ø60, provide replacement hinge pins, dowels and bushes
6925 21/01/2015 GENERAL PICKUP AND DELIVERY OF GOODS
6925 21/01/2015 ADAPTOR FLANGE
6925 21/01/2015 17 MALE TO 14 FEMALE SQUARE DRIVE
6917 16/01/2015 Drax, South Bucket Wheel Machine, machine out 290/295 dia shaft
6913 15/01/2015 Ø2242mm OD x 40mm thk Flange Machining
Turn the OD to Ø2242mm, bore to Ø2166mm only
To machine weld preps as per sketch
6913 15/01/2015 Ø2242mm OD x 40mm thk Flange Machining
Turn the OD to Ø2242mm, bore to Ø2166mm only
To machine weld preps as per sketch
6914 15/01/2015 BRUSH PLOUGH CARRIERS c/w MK1,2,3,12
6909 14/01/2015 MACHINING OF END CARRIAGE
6910 14/01/2015 MACHINING OF END CARRIAGE
6907 13/01/2015 Vent Pipe Elbow
6908 13/01/2015 OUTER BARREL ASSEMBLY
6908 13/01/2015 INNER BARREL
6904 12/01/2015 MACHINING OF END CARRIAGE
6905 12/01/2015 DETAIL OF SUCTION END BELL MACHINED TO ITEM 2 DIMENSION
6906 12/01/2015 AX 3.1/16 groove x 2
6902 09/01/2015 Skandi Arctic, Diving Bell Horizontal Sheave, machine Ø150-Ø300
6900 08/01/2015 Rail Bogie, worn damper bush housing
6898 07/01/2015 14 Dock RAH, Spring pack fitted bolt holes
6894 05/01/2015 Upper Tie Rod, on your site drilling of two 27.5 dia x 1810 deep holes on 250 pcd into one end face, M80 id x 312 od (360 dia x 12 p buttress thread)
Case Studies
View All >
Tartan Platform – Releasing Caisson from Dead Weight Support
The customer required a robust solution to release one of their caissons from a unique dead weight support structure. The caisson had a cone feature that nested into a mating cone in the platform support.
Find Out More >
Machining of Hang off Module (HOM) Rails on Deep Blue Vessel
The rails that the HOC runs on had become extremely worn and were affecting operations. The pair of rails, 11,080 mm long x 230mm wide, needed to be machined flat and to a common plane within 0.25mm.
Find Out More >